Search PCOTEC Products

TGIC polyester powder coating is a thermosetting coating system made mainly from carboxyl-functional polyester resin and TGIC curing agent.

Powder coating is a dry finishing process in which finely ground coating particles are electrostatically applied to a prepared surface and then heated until they melt, flow, and cure into a continuous film.

Powder coating is designed to resist impact, chemicals, weather, and normal abrasion, so removing it usually requires more than ordinary paint thinner.

Yes, stainless steel can be powder coated. It is electrically conductive, can accept electrostatically charged powder, and usually tolerates standard powder-curing temperatures.

Sanding between coats of polyurethane is not the same as sanding bare wood. The aim is to remove dust nibs, flatten small brush marks, and create a light mechanical key for the next coat without cutting through the finish.

Powder coating at home is possible for small metal parts, but it requires more than a spray gun and a household oven. The process uses electrically charged powder, a grounded workpiece, controlled ventilation, and enough heat to cure the coating into a continuous film.

Front-wheel-drive cars can perform well in light and moderate snow when they have suitable tires and are driven carefully.Because the engine and transmission are commonly positioned over or near the front axle, additional weight is placed above the driven wheels. This can help the vehicle move away from a stop on slippery roads.

Yes. Formula 1 cars are rear-wheel drive. The 2026 FIA technical regulations state that the transmission may only drive the two rear wheels. The rules also prohibit systems that automatically prevent the driven wheels from spinning under power.

Outdoor trash-can odor is normally caused by food liquid, organic waste, bacteria, heat, and moisture remaining inside the container. Spraying fragrance into the bin may temporarily cover the smell, but it does not remove the source.

Teak outdoor furniture is valued for its natural durability and attractive grain, but long-term exposure to sunlight, rain, dust, and temperature changes will gradually alter its appearance. Untreated teak commonly changes from a warm golden-brown color to a silver-gray patina.

A powder coating formula may look correct on paper, but production results can still fail when the resin system does not match the curing agent, pigment package, filler level, application temperature, or final coating requirement. This mismatch can create long testing cycles and delay customer approval.

Powder coating factories usually notice curing instability through finished coating problems, not through resin data sheets. A batch may pass mixing and extrusion smoothly, but after spraying and baking, the film shows unstable gloss, poor flow, weak adhesion, pinholes, or inconsistent outdoor resistance.